When.com Web Search

  1. Ads

    related to: 1965 mustang front end kit

Search results

  1. Results From The WOW.Com Content Network
  2. Fiberfab Avenger GT - Wikipedia

    en.wikipedia.org/wiki/Fiberfab_Avenger_GT

    The Avenger GT was the successor to the Aztec in Fiberfab's lineup. Some of the company's early documentation refers to it as the Aztec Avenger GT. [1] The Avenger GT's styling recalls the Ford GT40 — the Mk.I and Mk.III GT40s in particular — but is not an exact copy of the racing car.

  3. Fiberfab - Wikipedia

    en.wikipedia.org/wiki/Fiberfab

    Another of Fiberfab's early products was the E/T Mustang conversion. [21] This kit was designed by a moonlighting Larry Shinoda. [22] The final product looked somewhat like the nose of the mid-engined Ford Mustang I prototype. An estimated fifty E/T Mustang kits were produced by Fiberfab. One was installed on an original Shelby Mustang. [23]

  4. Ford Mustang (first generation) - Wikipedia

    en.wikipedia.org/wiki/Ford_Mustang_(first...

    When equipped with the 289 "HiPo" engine and a 4.11 rear axle ratio, the 1965 Mustang achieved 0–60 mph (0–97 km/h) in 5.2 seconds and a 1 ⁄ 4 mile (402 m) time of 14.0 seconds at 100 mph (161 km/h). [34] The 1966 Mustang debuted with moderate trim changes including a new grille, side ornamentation, wheel covers, and gas cap.

  5. CJ Pony Parts - Wikipedia

    en.wikipedia.org/wiki/CJ_Pony_Parts

    CJ Pony Parts has also featured multiple vehicles at The SEMA Show including a custom built 1965 Ford Mustang Fastback [3] and 2015 Ford Focus ST on behalf of Ford Motor Company. [4] Aside from Ford Mustang parts, CJ Pony Parts also carries parts for the Ford Focus ST , Ford Fiesta ST , F-150 and early model Ford Bronco along with Jeep ...

  6. Ford Mustang - Wikipedia

    en.wikipedia.org/wiki/Ford_Mustang

    From 1965 until 2004, the Mustang shared chassis commonality with other Ford model lines, staying rear-wheel-drive throughout its production. From 1965 to 1973, the Mustang was derived from the 1960 Ford Falcon compact. From 1974 until 1978, the Mustang (denoted Mustang II) was a longer-wheelbase version of the Ford Pinto.

  7. Ford Mustang variants - Wikipedia

    en.wikipedia.org/wiki/Ford_Mustang_variants

    The 427R featured the same suspension, power-train, and most of the body-kit of the Stage 3, but it lacked the rear fascia and rectangular exhaust tips of the various Stage models. It produced an additional 20 hp (14.91 kW) and 15 ft⋅lbf (20 N⋅m) of torque over the Stage 3 Mustang, due to an upgraded ECM (electronic control module).