Search results
Results From The WOW.Com Content Network
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system , a port is a logical construct that identifies a specific process or a type of network service .
A VLAN ID is added only if the frame is forwarded out a port configured as a trunk link. If the frame is to be forwarded out a port configured as an access link, the ISL encapsulation is removed. The size of an Ethernet encapsulated ISL frame can be expected to start from 94 bytes and increase up to 1548 bytes because of the overhead ...
Network-attached storage Hardware / Storage Computer data storage: NAT: Network Address Translation Internet Layer Cisco Internet Protocol Journal: A look Inside Network Address Translators: NBMA: Non-Broadcast Multiple Access (e.g. Frame Relay ATM) Telecom See ATM, Frame Relay and X.25, for examples. NIC: Network Interface Card Physical layer ...
Media Redundancy Protocol (MRP) is a data network protocol standardized by the International Electrotechnical Commission as IEC 62439-2. It allows rings of Ethernet switches to overcome any single failure with recovery time much faster than achievable with Spanning Tree Protocol. [1] It is suitable to most industrial Ethernet applications.
Network Address Translation (NAT), typically uses dynamic port numbers, on the public-facing side, to disambiguate the flow of traffic that is passing between a public network and a private subnetwork, thereby allowing many IP addresses (and their ports) on the subnet to be serviced by a single public-facing address.
The physical coding sublayer (PCS) is a networking protocol sublayer in the Fast Ethernet, Gigabit Ethernet, and 10 Gigabit Ethernet standards. It resides at the top of the physical layer (PHY), and provides an interface between the physical medium attachment (PMA) sublayer and the media-independent interface (MII).
In other words, a MAC should only be learned from a single switch's port. The SP network must learn all customer MAC addresses in order to switch them. This does not scale well. There is no provision in the above example for L2 protocol frames, Spanning Tree being the most important. Additional QoS capabilities are lacking.
The Serial Line Internet Protocol (SLIP) [1] [2] is an encapsulation of the Internet Protocol [a] designed to work over serial ports and router connections. It is documented in RFC 1055.