When.com Web Search

  1. Ads

    related to: 5.5 mm female to bulkhead connection male

Search results

  1. Results From The WOW.Com Content Network
  2. Coaxial power connector - Wikipedia

    en.wikipedia.org/wiki/Coaxial_power_connector

    There are a number of sizes listed below that appear to be quite similar, and while the tolerances of these connectors are typically indicated as ±0.05 or ±0.03 mm by the manufacturers, there is still ambiguity as to whether two sizes differing by only 0.05 mm (or where the specification is only given to the nearest 0.10 mm) warrants listing ...

  3. Gender of connectors and fasteners - Wikipedia

    en.wikipedia.org/wiki/Gender_of_connectors_and...

    Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.

  4. EIAJ connector - Wikipedia

    en.wikipedia.org/wiki/EIAJ_connector

    This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input).. Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter.

  5. DC connector - Wikipedia

    en.wikipedia.org/wiki/DC_connector

    The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:

  6. FASTON terminal - Wikipedia

    en.wikipedia.org/wiki/FASTON_terminal

    Six series are covered in one of TE's catalogs (which omits the 0.375 in/9.5 mm, but mentions it elsewhere), named after their blade width in mils. [3] Insulated versions of the terminals are color-coded to indicate what wire gauges they may be used with. The terminal system consists of tabs (male) and receptacles (female).

  7. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    Pressend / Female Thread Valve Connection Flange End-Connector Elbow 90°, F/F & F/M Elbow 45°, F/F & F/M Bend 15°, 45°, 75° M/M Coupling Coupling Long Tee Elbow 90° Male Coupling Bend 90° Male Thread Tee Male Union Male Coupling Male Straight Connector Elbow 90° Female Coupling Double Tap Connector 90/90 with Female Thread Elbow 90 ...