Ads
related to: replacing control arm bushings 07 pt cruiser engine mount bracket to engine torque spec porsche 993
Search results
Results From The WOW.Com Content Network
Check the Control arm bushings. The driver will experience torque steer when accelerating because of worn out control-arm bushings. Rear-wheel-drive vehicles still are affected by torque steer in the sense that any of the above situations will still apply a steering moment to the car (though from the rear wheels instead of the front).
A rubber bushing may also be described as a flexible mounting or antivibration mounting. These bushings often take the form of an annular cylinder of flexible material inside a metallic casing or outer tube. They might also feature an internal crush tube which protects the bushing from being crushed by the fixings which hold it onto a threaded ...
The inboard (chassis) end of a control arm is attached by a single pivot, usually a rubber bushing. It can thus control the position of the outboard end in only a single degree of freedom, maintaining the radial distance from the inboard mount. Although not deliberately free to move, the single bushing does not control the arm from moving back ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing) on one end to the wheel carrier or axle, on the other to the chassis or unibody of the vehicle. Radius rods are ...
It was developed as a replacement for the earlier single-cam 2.2L and 2.5L turbo engines that were very popular in Mexico. EDZ 2.4L DOHC turbocharged engine used in a Mexican Stratus R/T & Cirrus (1996-2000) The turbocharged EDV/EDT was initially developed for the PT Cruiser GT as a way to add power, and is similar to the regular EDZ. As the PT ...
The transmission of load provides an increase in steering control accuracy going into a corner, reducing the possibility of the vehicle sliding or losing traction. [1] To accomplish this effectively (especially on MacPherson strut suspensions), the bar must be rigid throughout its length.