When.com Web Search

  1. Ad

    related to: basement below grade vs daylight floor fan motor bearings diagram

Search results

  1. Results From The WOW.Com Content Network
  2. Grade beam - Wikipedia

    en.wikipedia.org/wiki/Grade_beam

    Grade beam. A grade beam or grade beam footing is a component of a building's foundation. It consists of a reinforced concrete beam that transmits the load from a bearing wall into spaced foundations such as pile caps or caissons. [1] It is used in conditions where the surface soil's load-bearing capacity is less than the anticipated design loads.

  3. Basement - Wikipedia

    en.wikipedia.org/wiki/Basement

    Some daylight basements are located on slopes, such that one portion of the floor is at-grade with the land. A walk-out basement almost always results from this. Most daylight basements naturally result from raised bungalows and at-grade walk-out basements. However, there are instances where the terrain dips enough from one side to another to ...

  4. Daylighting (architecture) - Wikipedia

    en.wikipedia.org/wiki/Daylighting_(architecture)

    The useful daylight illuminance calculation is based on three factors—the percentage of time a point is below, between, or above an illuminance value. The range for these factors is typically 100–2,000 lux. Useful daylight illuminance is similar to daylight autonomy but has the added benefit of addressing glare and thermal discomfort. [44]

  5. Shallow foundation - Wikipedia

    en.wikipedia.org/wiki/Shallow_foundation

    Soil conditions may prevent other footings from being used. Since this type of foundation distributes the load coming from the building uniformly over a considerably large area, it is favored when individual footings are unfeasible due to the low bearing capacity of the soil. Diagrams of the types of shallow foundations.

  6. Main bearing - Wikipedia

    en.wikipedia.org/wiki/Main_bearing

    The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).

  7. Soft White vs. Daylight Bulbs: When to Use What in Your Home

    www.aol.com/soft-white-vs-daylight-bulbs...

    For premium support please call: 800-290-4726 more ways to reach us more ways to reach us

  8. Mechanical floor - Wikipedia

    en.wikipedia.org/wiki/Mechanical_floor

    Mechanical attic (fourth floor) in Moore Hall at UCLA. A mechanical floor, mechanical penthouse, mechanical layer or mechanical level is a story of a high-rise building that is dedicated to mechanical and electronics equipment. "Mechanical" is the most commonly used term, but words such as utility, technical, service, and plant are also used.

  9. Campbell diagram - Wikipedia

    en.wikipedia.org/wiki/Campbell_diagram

    Campbell Diagram of a steam turbine. Analysis shows that there are well-damped critical speed at lower speed range. Analysis shows that there are well-damped critical speed at lower speed range. Another critical speed at mode 4 is observed at 7810 rpm (130 Hz) in dangerous vicinity of nominal shaft speed, but it has 30% damping - enough to ...