Ads
related to: buffer solutions chemistry
Search results
Results From The WOW.Com Content Network
A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...
Phosphate-buffered saline (PBS) is a buffer solution (pH ~ 7.4) commonly used in biological research. It is a water-based salt solution containing disodium hydrogen phosphate, sodium chloride and, in some formulations, potassium chloride and potassium dihydrogen phosphate. The buffer helps to maintain a constant pH.
A category for buffering agents and buffer solutions made with them. Pages in category "Buffer solutions" The following 39 pages are in this category, out of 39 total
The useful buffer range for tris (pH 7–9) coincides with the physiological pH typical of most living organisms. This, and its low cost, make tris one of the most common buffers in the biology/biochemistry laboratory. Tris is also used as a primary standard to standardize acid solutions for chemical analysis.
A simple buffer solution consists of a solution of an acid and a salt of the conjugate base of the acid. For example, the acid may be acetic acid and the salt may be sodium acetate . The Henderson–Hasselbalch equation relates the pH of a solution containing a mixture of the two components to the acid dissociation constant , K a of the acid ...
Good's buffers (also Good buffers) are twenty buffering agents for biochemical and biological research selected and described by Norman Good and colleagues during 1966–1980. [ 1 ] [ 2 ] [ 3 ] Most of the buffers were new zwitterionic compounds prepared and tested by Good and coworkers for the first time, though some ( MES , ADA , BES , Bicine ...
Buffering HF with NH 4 F results in a solution with a more stable pH; thus, more stable concentrations of HF and HF − 2, and a more stable etch rate. [2] Some oxides produce insoluble products in HF solutions. Thus, HCl may be added to BHF solutions in order to dissolve these insoluble products and produce a higher quality etch. [3]
TAE buffer is commonly prepared as a 50× stock solution for laboratory use. A 50× stock solution can be prepared by dissolving 242 g Tris base in water, adding 57.1 ml glacial acetic acid, and 100 ml of 500 mM EDTA (pH 8.0) solution, and bringing the final volume up to 1 litre.