Search results
Results From The WOW.Com Content Network
The normal key on the left will open only the lock that it goes to, but the skeleton key on the right will open any lock with this particular keyhole. Two warded lock keys and a homemade skeleton key A skeleton key (also known as a passkey [ 1 ] ) is a type of master key in which the serrated edge has been removed in such a way that it can open ...
Lock picking is the practice of unlocking a lock by manipulating the components of the lock device without the original key. Although lock-picking can be associated with criminal intent , it is an essential skill for the legitimate profession of locksmithing , and is also pursued by law-abiding citizens as a useful skill to learn, or simply as ...
The safecracker will drill a hole allowing him to get his scope into a position to observe the change key hole. While spinning the dial and looking through the change key hole for certain landmarks on the combination lock's wheel pack, it is possible to obtain the combination and then dial open the safe with the correct combination.
The same physical principles are involved in lock bumping, but the snap gun automates the transfer-of-energy process. A correctly applied snap gun can open a lock very quickly compared to traditional lock picking, but the sharp impact is more likely to damage the lock mechanism than raking, which mimics normal key movements.
A lock bypass is a technique in lockpicking, of defeating a lock through unlatching the underlying locking mechanism without operating the lock at all. It is commonly used on devices such as combination locks, where there is no natural access (such as a keyhole) for a tool to reach the locking mechanism.
Because a bump key must only have the same blank profile as the lock it is made to open, restricted or registered key profiles are not any safer from bumping. While the correct key blanks cannot be obtained legally without permission or registration with relevant locksmith associations, regular keys can be filed down to act as bump keys.
In a pinch? Here’s how to open cans without a can opener. Picture this: You’re in the middle of making dinner and go to open a can of something you absolutely need for the recipe.
Master pin In a pin tumbler lock, a master pin is an optional, usually short, disk-like pin placed between the top and bottom pins. Its purpose is to allow two differently-cut keys to open the lock. Master pins are also called master wafers. Plug The plug is the part of a cylinder lock which is designed to turn when a key is inserted. Plug follower