Search results
Results From The WOW.Com Content Network
If you're using broadband (cable) internet and you can't connect, try the following troubleshooting steps in the order listed until you get up and running again. 1. Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using.
This command returns information about the model, such as its firmware or brand name. Each number (0 to 9, and sometimes 10 and above) returns one line of modem-specific information, or the word ERROR if the line is not defined. Today, Windows uses this for Plug-and-play detection of specific modem types. L0 or Ln (n=1 to 3) Speaker Loudness.
The calling modem waits for the tone after it dials the phone line before it initiates data transmission. If it does not receive a carrier tone within a set amount of time, it will disconnect the phone line and issues the NO CARRIER message. The actual data is transmitted from the answering modem to the calling modem via modulation of the carrier.
With AOL Dialer set as your default dialer, you can connect to the Internet by launching most Internet applications like web browsers or AOL Desktop Gold. The Dialer will launch automatically and prompt you to sign in. Note: This method may not work with all Internet applications. To connect with the Dialer first:
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end. After answering the phone automatically for some pre-configured reason (such as auto-answer), and connecting to another modem.
A wireless router allows wired and wireless Ethernet LAN devices to connect to a (usually) single WAN device such as a cable modem, DSL modem, or optical modem. A wireless router allows all three devices, mainly the access point and router, to be configured through one central utility.
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router