Search results
Results From The WOW.Com Content Network
The limiting reagent (or limiting reactant or limiting agent) in a chemical reaction is a reactant that is totally consumed when the chemical reaction is completed. [ 1 ] [ 2 ] The amount of product formed is limited by this reagent, since the reaction cannot continue without it.
As an example, consider the gas-phase reaction NO 2 + CO → NO + CO 2.If this reaction occurred in a single step, its reaction rate (r) would be proportional to the rate of collisions between NO 2 and CO molecules: r = k[NO 2][CO], where k is the reaction rate constant, and square brackets indicate a molar concentration.
To find the limiting reagent and the mass of HCl produced by the reaction, we change the above amounts by a factor of 90/324.41 and obtain the following amounts: 90.00 g FeCl 3, 28.37 g H 2 S, 57.67 g Fe 2 S 3, 60.69 g HCl. The limiting reactant (or reagent) is FeCl 3, since all 90.00 g of it is used up while only 28.37 g H 2 S are consumed.
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
Stoichiometric equations are used to determine the limiting reagent or reactant—the reactant that is completely consumed in a reaction. The limiting reagent determines the theoretical yield—the relative quantity of moles of reactants and the product formed in a chemical reaction. Other reactants are said to be present in excess.
If we assume a local steady state, then the rate at which B reaches is the limiting factor and balances the reaction. Therefore, the steady state condition becomes 1. [] = where is the flux of B, as given by Fick's law of diffusion, 2.
In chemistry, a reagent (/ r i ˈ eɪ dʒ ən t / ree-AY-jənt) or analytical reagent is a substance or compound added to a system to cause a chemical reaction, or test if one occurs. [1] The terms reactant and reagent are often used interchangeably, but reactant specifies a substance consumed in the course of a chemical reaction. [ 1 ]
General reaction scheme for the S N 1 reaction. The leaving group is denoted "X", and the nucleophile is denoted "Nu–H". The unimolecular nucleophilic substitution (S N 1) reaction is a substitution reaction in organic chemistry.