Ad
related to: 1.72 in feet and inches conversion to decimal degrees table of chart meaning
Search results
Results From The WOW.Com Content Network
With the invention of the metric system, based on powers of ten, there was an attempt to replace degrees by decimal "degrees" in France and nearby countries, [note 3] where the number in a right angle is equal to 100 gon with 400 gon in a full circle (1° = 10 ⁄ 9 gon). This was called grade (nouveau) or grad.
1:72 scale is a scale used for scale models, most commonly model aircraft, where one inch on the model equals six feet (which is seventy-two inches) in real life. The scale is popular for aircraft because sizes ranging from small fighters to large bombers are all reasonably manageable and displayable.
This table shows the diagonal, horizontal, and vertical angles of view, in degrees, for lenses producing rectilinear images, when used with 36 mm × 24 mm format (that is, 135 film or full-frame 35 mm digital using width 36 mm, height 24 mm, and diagonal 43.3 mm for d in the formula above). [16]
This material which must have started out like unfired pottery was slip cast from fused silica. Then it was dried four days at 333 K before being tested. It was 9 inches in diameter and 1 inch thick, density 1.78 ⋅ cm −3. The first run went to 1317K and then on the second run the same insulator proved to be more conductive. 1959. [110 ...
15.24 meters – width of an NBA basketball court (50 feet) 18.44 meters – distance between the front of the pitcher's rubber and the rear point of home plate on a baseball field (60 feet, 6 inches) [125] 20 meters – length of cricket pitch (22 yards) [126] 27.43 meters – distance between bases on a baseball field (90 feet)
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length. For a baseline, ring size C has a circumference of 40 mm. [7]
Albuquerque (/ ˈ æ l b ə k ɜːr k i / ⓘ AL-bə-kurk-ee; Spanish: [alβuˈkeɾke] ⓘ), [a] also known as ABQ, Burque, and the Duke City, is the most populous city in the U.S. state of New Mexico, [5] and the county seat of Bernalillo County.