Ads
related to: floppy disk drive interface for mac pro 16
Search results
Results From The WOW.Com Content Network
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
It supported all of Apple's 3.5" floppy disk formats as well as all standard PC formats (e.g. MS-DOS, Windows), allowing the Macintosh to read and write all industry-standard floppy disk formats. The external drive was offered only briefly with support for the Apple II, coming late in that product's life.
Internal SuperDrive floppy drive on a Macintosh LC II. The term was first used by Apple Computer in 1988 to refer to their 1.44 MB 3.5 inch floppy drive.This replaced the older 800 KB floppy drive that had been standard in the Macintosh up to then, but remained compatible [citation needed] in that it could continue to read and write both 800 KB (double-sided) and 400 KB (single-sided) floppy ...
1 Floppy disk drives. 2 Hard disk drives. 3 Optical drives. 4 Other drives. Toggle the table of contents. ... Apple MacBook Air SuperDrive; Other drives. Apple Tape ...
The drive itself is the same size as a standard 3.5″ floppy drive, but uses an ATA interface. On the right is the USB-to-ATA adapter, which plugs into an intermediate fan-out and power supply daughterboard that is inside the rear of the Mac drive's casing. This particular drive cannot function using USB power alone.
The drive is approximately the same size as a standard full-height 5¼ inch floppy drive, but does not use the standard mounting hole locations. The electrical interface is completely different from that of standard drives, though conceptually similar to that of the Disk II.
A volume can have a capacity of up to 32 megabytes, and each file can be up to 16 megabytes. Each volume (floppy disk or hard drive partition) has a "volume name", a filename which is used as the base directory name; having two volumes with the same volume name can result in conflicts. If necessary, ProDOS searches all available drives to find ...
Perhaps the most common cards found on early Apple II systems were the Disk II Controller Card, which allowed users of earlier Apple IIs to use the Apple Disk II, a 5¼ inch, 140 kB floppy disk drive; and the Apple 16K Language Card, which increased the base memory of late-model Apple II and standard Apple II Plus units from 48 kB to 64 kB.