Search results
Results From The WOW.Com Content Network
When the load factor is greater than +1 all occupants feel heavier than usual. For example, in a 2 g maneuver all occupants feel that their weight is twice normal. When the load factor is zero, or very small, all occupants feel weightless. [2]: 398 When the load factor is negative, all occupants feel that they are upside down.
Load factor may refer to: Load factor (aeronautics), the ratio of the lift of an aircraft to its weight; Load factor (computer science), the ratio of the number of records to the number of addresses within a data structure; Load factor (electrical), the average power divided by the peak power over a period of time
A load case is a combination of different types of loads with safety factors applied to them. A structure is checked for strength and serviceability against all the load cases it is likely to experience during its lifetime. Typical load cases for design for strength (ultimate load cases; ULS) are: 1.2 x Dead Load + 1.6 x Live Load
This formula also shows that the radius of turn decreases with the angle of bank. With a higher angle of bank the radius of turn is smaller, and with a lower angle of bank the radius is greater. In a banked turn at constant altitude, the load factor is equal to .
In physics, Hooke's law is an empirical law which states that the force (F) needed to extend or compress a spring by some distance (x) scales linearly with respect to that distance—that is, F s = kx, where k is a constant factor characteristic of the spring (i.e., its stiffness), and x is small compared to the total possible deformation of the spring.
If a load is applied sufficiently slowly, the inertia forces (Newton's first law of motion) can be ignored and the analysis can be simplified as static analysis. A static load is one which varies very slowly. A dynamic load is one which changes with time fairly quickly in comparison to the structure's natural frequency.
Deflection (f) in engineering. In structural engineering, deflection is the degree to which a part of a long structural element (such as beam) is deformed laterally (in the direction transverse to its longitudinal axis) under a load.
A factor of safety is a design criteria that an engineered component or structure must achieve. = /, where FS: the factor of safety, Rf The applied stress, and F: ultimate allowable stress (psi or MPa) [13] Margin of Safety is the common method for design criteria. It is defined MS = P u /P − 1.