Search results
Results From The WOW.Com Content Network
Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal) A well with 5,000 feet of seawater and 15,000 feet of rock could have an overburden pressures at the bottom as high as 17,220 psi (5000 * 0.444 ...
pound (avoirdupois) per cubic foot lb/ft 3: ≡ lb/ft 3: ≈ 16.018 463 37 kg/m 3: pound (avoirdupois) per cubic inch lb/in 3: ≡ lb/in 3: ≈ 2.767 990 471 × 10 4 kg/m 3: pound (avoirdupois) per gallon (imperial) lb/gal ≡ lb/gal ≈ 99.776 372 66 kg/m 3: pound (avoirdupois) per gallon (US fluid) lb/gal ≡ lb/gal ≈ 119.826 4273 kg/m 3 ...
{{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.
For example, if a unit has the symbol "imp gal", and if the link is @[[Gallon]], then if the symbol is linked, it would appear as "imp gal" ("imp" and "gal" link two different articles). The Links section defines exceptions for unit codes with an SI prefix, where the linked article is different from that of the base unit.
1.0 N⋅m (0.74 lbf⋅ft) Nm kg.m; Nm lb.ft; Non-SI metric: kilogram metre: kg.m kg⋅m 1.0 kg⋅m (9.8 N⋅m; 7.2 lb⋅ft) kg.m Nm; kg.m lb.ft; Imperial & US customary: pound force-foot: lb.ft lb⋅ft 1.0 lb⋅ft (1.4 N⋅m) lb.ft Nm; lb.ft kg-m; Scientific: SI: newton-metre: N.m N⋅m Triple combinations are also possible. See the full list ...
The kilopound per square inch (ksi) is a scaled unit derived from psi, equivalent to a thousand psi (1000 lbf/in 2). ksi are not widely used for gas pressures. They are mostly used in materials science, where the tensile strength of a material is measured as a large number of psi. [4] The conversion in SI units is 1 ksi = 6.895 MPa, or 1 MPa ...
In petroleum geology and the petrochemical sciences pertaining to oil wells, and more specifically within hydrostatics, pressure gradients refer to the gradient of vertical pressure in a column of fluid within a wellbore and are generally expressed in pounds per square inch per foot (psi/ft). This column of fluid is subject to the compound ...
HSP = 0.052 × MW × TVD', where MW (Mud Weight or density) is the drilling-fluid density in pounds per gallon (ppg), TVD is the true vertical depth in feet and HSP is the hydrostatic pressure in psi. The 0.052 is needed as the conversion factor to psi unit of HSP. [10] [11] To convert these units to SI units, one can use: 1 ppg ≈ 119.826 ...