Ads
related to: plywood vs osb underfloor ceiling
Search results
Results From The WOW.Com Content Network
Oriented strand board (OSB) is a type of engineered wood, formed by adding adhesives and then compressing layers of wood strands (flakes) in specific orientations. It was invented by Armin Elmendorf in California in 1963. [ 1 ]
Plywood is a composite material manufactured from thin layers, or "plies", of wood veneer that have been stacked and glued together. It is an engineered wood from the family of manufactured boards, which include plywood, medium-density fibreboard (MDF), oriented strand board (OSB), and particle board (or chipboard).
Other materials can be used in replacement of OSB, such as plywood, pressure-treated plywood for below-grade foundation walls, steel, [1] aluminum, cement board such as Hardiebacker, and even exotic materials like stainless steel, fiber-reinforced plastic, and magnesium oxide.
Manufactured trusses – trusses are used in home construction as a pre-fabricated replacement for roof rafters and ceiling joists (stick-framing). It is seen as an easier installation and a better solution for supporting roofs than the use of dimensional lumber's struts and purlins as bracing.
Vapor retarder paints (for the air-tight drywall system, for retrofits where finished walls and ceilings will not be replaced, or for dry basements: can break down over time due to being chemically based). Extruded polystyrene or foil-faced foam board insulation. Exterior grade plywood, 0.70 US perm (40 SI perm).
Birch plywood is commonly used as the substrate in engineered flooring due to its strength, durability, and waterproof properties. It is composed of several thin layers of birch veneer core glued together. It is well-suited for commercial vehicle flooring and trailer decking for its flexibility and ability to endure heavy foot traffic. [5]
[1] [2] It is similar to plywood but with distinctively thicker laminations (or lamellae). The grain of each layer of boards is usually rotated 90 degrees from that of adjacent layers and glued on the wide faces of each board, usually in a symmetric way so that the outer layers have the same orientation. An odd number of layers is most common ...
While plywood became widespread by the early 20th century, the invention of LVL was not until the 1980s after the invention of oriented strand board. [3] The American Wood Council's National Design Specification for Wood Construction is generally updated on a 3- to 5-year cycle. The 1991 release is the first release which mentions LVL.