Search results
Results From The WOW.Com Content Network
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
Only a fluid characterized by Chrysler specification MS-9224 should be used in order to avoid premature wear or failure of internal parts as well as voiding the factory warranty. [2] Pennzoil Synchromesh is one such petroleum based lubricant. [3] Transmissions from Jeep wranglers Length: 23.5" (I6), 24.8" (V6).
The Dana 18 is a gear driven part-time transfer case. [2] Both the front and rear output shafts are offset towards the passenger side of the vehicle. Drive modes offered include 2-wheel high, part-time 4-wheel high, and part-time 4-wheel Low. All Dana 18 cases are cast iron and use the "Texas" bolt pattern with five bolts holding on the ...
1984-1997 Jeep Wagoneer; 1984-2001 Jeep Cherokee; 1993-2004 Jeep Grand Cherokee; 1986-1992 Jeep Comanche; 1987-1995 Jeep YJ Wrangler Note: there was no 96 model. 1997-2006 Jeep TJ Wrangler *option Dana 44 rear and Rubicon's had Dana 44's; 2007 only some early Jeep JK 2 door Wranglers had Dana 35 non c-clip axles. 2001-2007 Jeep Liberty; Dodge ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The "GEN-3" engines were available in Jeep utility vehicles starting in 1971. [3] It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5]
The 9HP is only 0.24 inches (6 mm) longer than, and weighs 16.5 lbs (7.5 kg) less than, the outgoing six-speed transmission. The compact packaging is achieved by using a number of innovative design features: a new compact hydraulic vane-type pump, two patented dog clutches, [3] which replace bulkier conventional clutch packs, and a nested gear set. [2]
Calibration verification numbers (CVN) message count for PID 06. Only for ISO 9141-2, ISO 14230-4 and SAE J1850. 06: 4,8,12,16 Calibration Verification Numbers (CVN) Several CVN can be output (4 bytes each) the number of CVN and CALID must match Raw data left-padded with null characters (0x00). Usually displayed as hex string. 07: 1