Search results
Results From The WOW.Com Content Network
A photoresistor can be used in light-sensitive detector circuits and light-activated and dark-activated switching circuits acting as a semiconductor resistance. In the dark, a photoresistor can have a resistance as high as several megaohms (MΩ), while in the light, it can have a resistance as low as a few hundred ohms.
Such an electron is collected by a suitable external readout integrated circuits (ROIC) and transformed into an electric signal. LEDs which are reverse-biased to act as photodiodes. See LEDs as photodiode light sensors. Photoresistors or Light Dependent Resistors (LDR) which change resistance according to light intensity. Normally the ...
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
Opto-isolator VTL2C1 with LED input and photoresistor output. Resistive opto-isolator (RO), also called photoresistive opto-isolator, vactrol (after a genericized trademark introduced by Vactec, Inc. in the 1960s), analog opto-isolator [notes 1] or lamp-coupled photocell, [1] is an optoelectronic device consisting of a source and detector of light, which are optically coupled and electrically ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
A sensor is a transducer that receives and responds to a signal or stimulus from a physical system. [3] [4] [2] It produces a signal, which represents information about the system, which is used by some type of telemetry, information or control system. An actuator is a device that is responsible for moving or controlling a mechanism or system.
Cutaway view of an LVDT. Current is driven through the primary coil at A, causing an induction current to be generated through the secondary coils at B.. The linear variable differential transformer (LVDT) – also called linear variable displacement transformer, [1] linear variable displacement transducer, [2] or simply differential transformer [3] – is a type of electrical transformer [4 ...
The passive-pixel sensor (PPS) is a type of photodiode array. It was the precursor to the active-pixel sensor (APS). [20] A passive-pixel sensor consists of passive pixels which are read out without amplification, with each pixel consisting of a photodiode and a MOSFET switch. [24]