Search results
Results From The WOW.Com Content Network
The cut-off voltage is different from one battery to the other and it is highly dependent on the type of battery and the kind of service in which the battery is used. When testing the capacity of a NiMH or NiCd battery a cut-off voltage of 1.0 V per cell is normally used, whereas 0.9 V is normally used as the cut-off voltage of an alkaline cell ...
It is the time required to charge the capacitor, through the resistor, from an initial charge voltage of zero to approximately 63.2% of the value of an applied DC voltage, or to discharge the capacitor through the same resistor to approximately 36.8% of its initial charge voltage.
The remaining capacity can also be withdrawn by reducing the current. For example, when the battery in the previous example reaches the cut-off voltage at 200 A, tapering the current down as necessary to keep the voltage at the low voltage cut-off value will enable nearly all the missing capacity to be taken from the battery (albeit over a ...
The simplest inrush-current limiting system, used in many consumer electronics devices, is a NTC resistor. When cold, its high resistance allows a small current to pre-charge the reservoir capacitor. After it warms up, its low resistance more efficiently passes the working current. Many active power factor correction systems also include soft ...
A charge pump is a kind of DC-to-DC converter that uses capacitors for energetic charge storage to raise or lower voltage. Charge-pump circuits are capable of high efficiencies , sometimes as high as 90–95%, while being electrically simple circuits.
An intelligent charger may monitor the battery's voltage, temperature or charge time to determine the optimum charge current or terminate charging. For Ni–Cd and Ni–MH batteries , the voltage of the battery increases slowly during the charging process, until the battery is fully charged.
Qi (/ tʃ iː / CHEE) is an open standard for inductive charging developed by the Wireless Power Consortium.It allows compatible devices, such as smartphones, to receive power when placed on a Qi charger, which can be effective over distances up to 4 cm (1.6 in). [1]
Depth of discharge (DoD) is an important parameter appearing in the context of rechargeable battery operation. Two non-identical definitions can be found in commercial and scientific sources. The depth of discharge is defined as: the maximum fraction of a battery's capacity (given in Ah) which is removed from the charged battery on a regular basis.