Search results
Results From The WOW.Com Content Network
Spalling can also occur as an effect of cavitation, where fluids are subjected to localized low pressures that cause vapour bubbles to form, typically in pumps, water turbines, vessel propellers, and even piping under some conditions. When such bubbles collapse, a localized high pressure can cause spalling on adjacent surfaces.
Spallation can occur when a tensile stress wave propagates through a material and can be observed in flat plate impact tests. It is caused by an internal cavitation due to stresses, which are generated by the interaction of stress waves, exceeding the local tensile strength of materials.
Delamination is a mode of failure where a material fractures into layers. A variety of materials, including laminate composites [ 1 ] and concrete , can fail by delamination. Processing can create layers in materials, such as steel formed by rolling [ 2 ] [ 3 ] and plastics and metals from 3D printing [ 4 ] [ 5 ] which can fail from layer ...
If concrete is exposed to very high temperatures very rapidly, explosive spalling of the concrete can result. In a very hot, very quick fire the water inside the concrete will boil before it evaporates. The steam inside the concrete exerts expansive pressure and can initiate and forcibly expel a spall. [23]
The difference in densities can be explained by thermal expansion/contraction, composition, and phase changes. [2] Negative buoyancy of the lower continental crust and mantle lithosphere drive delamination. [3] Delamination occurs when the lower continental crust and mantle lithosphere break away from the upper continental crust.
Exfoliating slabs of granite, on Half Dome in Yosemite National Park, USA. Exfoliating granite is a granite undergoing exfoliation, or onion skin weathering (desquamation).The external delaminated layers of granite are gradually produced by the cyclic variations of temperature at the surface of the rock in a process also called spalling.
In fracture mechanics, the energy release rate, , is the rate at which energy is transformed as a material undergoes fracture.Mathematically, the energy release rate is expressed as the decrease in total potential energy per increase in fracture surface area, [1] [2] and is thus expressed in terms of energy per unit area.
The periodic variations are often interpreted as periodic removal of some of the deposit (perhaps deposit re-suspension due to pressure pulses, spalling due thermal stresses, or exfoliation due to redox transients). Steam blanketing has been postulated to occur between the partially spalled deposits and the heat transfer surface.