When.com Web Search

  1. Ads

    related to: centrifugal water pump small block magnum

Search results

  1. Results From The WOW.Com Content Network
  2. Centrifugal pump - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_pump

    Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed]

  3. Comparison of pumps - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_pumps

    Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

  4. Centrifugal pump selection and characteristics - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_pump_selection...

    While centrifugal pumps impart momentum to the fluid by motion of blades, positive displacement pumps transfer fluid by variation in the size of the pump’s chamber. Centrifugal pumps can be of rotor or propeller types, whereas positive displacement pumps may be gear-based, piston-based, diaphragm-based, etc. As a general rule, centrifugal ...

  5. Circulating water plant - Wikipedia

    en.wikipedia.org/wiki/Circulating_Water_Plant

    Horizontal, centrifugal pumps for clear, cold fresh water 4 IS: 1536 Centrifugally cast (spun) iron pressure pipes for water, gas and sewage 5 IS: 1537 Vertically cast iron pressure pipes for water, gas and sewage 6 IS: 1710 Vertical turbine pumps for clear, cold fresh water 7 IS: 2002 Steel plates for boilers 8 IS: 2062

  6. Turbopump - Wikipedia

    en.wikipedia.org/wiki/Turbopump

    There are two common types of pumps used in turbopumps: a centrifugal pump, where the pumping is done by throwing fluid outward at high speed, or an axial-flow pump, where alternating rotating and static blades progressively raise the pressure of a fluid. Axial-flow pumps have small diameters but give relatively modest pressure increases.

  7. Boiler feedwater pump - Wikipedia

    en.wikipedia.org/wiki/Boiler_feedwater_pump

    In this situation, though, the pump was often powered using a small steam engine that ran using the steam produced by the boiler. A means had to be provided, of course, to put the initial charge of water into the boiler (before steam power was available to operate the steam-powered feedwater pump).