Search results
Results From The WOW.Com Content Network
Fuel tanks of a capacity greater than 25 US gallons must adhere to specifications for spillage, leakage, mounting, impact survivability, weld requirements, venting and a host of other stipulations. The regulations require side-mounted fuel tanks to survive a 30-foot drop test, while non-side-mounted fuel tanks must survive a 10-foot drop test.
Hydrochloric acid, also known as muriatic acid or spirits of salt, is an aqueous solution of hydrogen chloride (HCl). It is a colorless solution with a distinctive pungent smell. It is classified as a strong acid. It is a component of the gastric acid in the digestive systems of most animal species, including humans.
FUEL DATA FOR 4-CYLINDER ENGINE TYPE : Diesel GALLONS PER HOUR: 1.5 U.S. gallons (5.7 L; 1.2 imp gal) Self Onload - 300gpm Offload - 600 pgm FORDING CAPABILITY: Can ford hard, flat bottoms. Depth depends on prime mover and semitrailer payload (fuel is lighter than water and will float) Without a fording kit the tanker can enter 24 in (610 mm ...
Due to the higher density, diesel fuel offers a higher volumetric energy density: the density of EN 590 diesel fuel is defined as 0.820 to 0.845 kg/L (6.84 to 7.05 lb/US gal) at 15 °C (59 °F), about 9.0-13.9% more than EN 228 gasoline (petrol)'s 0.720–0.775 kg/L (6.01–6.47 lb/US gal) at 15 °C, which should be put into consideration when ...
Diesel exhaust fluid (DEF; also known as AUS 32 and sometimes marketed as AdBlue [3]) is a liquid used to reduce the amount of air pollution created by a diesel engine. Specifically, DEF is an aqueous urea solution made with 32.5% urea and 67.5% deionized water .
Specific energy is energy per unit mass, which is used to describe the chemical energy content of a fuel, expressed in SI units as joule per kilogram (J/kg) or equivalent units. [1] Energy density is the amount of chemical energy per unit volume of the fuel, expressed in SI units as joule per litre (J/L) or equivalent units. [2]
ppg – pounds per gallon; PPI – post production inspection/intervention; PPI – post pipelay installation; PPL – pre-perforated liner; pptf – pounds (per square inch) per thousand feet (of depth) – a unit of fluid density/pressure [citation needed] PPS – production packer setting; PPU – pipeline process and umbilical
Assuming the Emma Maersk consumes diesel (as opposed to fuel oil which would be the more precise fuel) then 1 kg diesel = 1.202 litres = 0.317 US gallons. This corresponds to 46,525 kJ. Assuming a standard 14 tonnes per container (per teu) this yields 74 kJ per tonne-km at a speed of 45 km/h (24 knots).