Ads
related to: hand crank lift mechanism kit for car
Search results
Results From The WOW.Com Content Network
According to F. Lisheng and T. Qingjun, the hand-crank of the rotary quern was different from a crank, which was the combination of a hand-crank and a push-and-pull connecting rod by a hinge. [7] The Antikythera mechanism, dated to around 200 BC, [25] [26] used a crank as a part of its mechanism. [27]
Packard had introduced hydraulic window lifts (power windows) in fall of 1940, for its new 1941 Packard 180 series cars. [ 1 ] [ 2 ] This was a hydro-electric system. In 1941, the Ford Motor Company followed with the first power windows on the Lincoln Custom (only the limousine and seven-passenger sedans). [ 3 ]
Movie projector with hand crank and Geneva drive. One application of the Geneva drive is in film movie projectors and movie cameras, where the film is pulled through an exposure gate with periodic starts and stops. The film advances frame by frame, each frame standing still in front of the lens for a portion of the frame cycle (typically at a ...
A jack which can lift a mobile home. A jack is a mechanical lifting device used to apply great forces or lift heavy loads. A mechanical jack employs a screw thread for lifting heavy equipment. A hydraulic jack uses hydraulic power. [1] The most common form is a car jack, floor jack or garage jack, which lifts vehicles so that maintenance can be ...
A coupler connecting a crank and a slider in a single slider crank mechanism is often called a connecting rod, however, it has also been used to refer to any type of coupler. There are three basic types of planar four-bar linkage, depending on the use of revolute or prismatic joints: Four revolute joints:
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
3-wheeled handcar or velocipede on a railroad track Preserved railroad velocipede on exhibit at the Toronto Railway Historical Association. A handcar (also known as a pump trolley, pump car, rail push trolley, push-trolley, jigger, Kalamazoo, [1] velocipede, or draisine) is a railroad car powered by its passengers or by people pushing the car from behind.
This is a vertical spool with a ratchet mechanism similar to a conventional winch, but with no crank handle or other form of drive. [7] The line is wrapped around the spool and can be tightened or reeled in by pulling the tail line. The winch takes the load once the pull is stopped with little operator tension needed to hold it.