Ads
related to: 3.5 floppy disk drive internal space
Search results
Results From The WOW.Com Content Network
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
Capacity indication (a hole that indicates a high-capacity disk). Hub (engages with the drive motor). Shutter (protects the surface when diskette is removed from the drive). Plastic housing (the external case). Paper ring (a polyester sheet reducing friction against the disk media as it rotates within the housing).
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
They were 3 + 1 ⁄ 4 inches (82.6 mm) high, 5 + 3 ⁄ 4 inches (146.1 mm) wide, and up to 8 inches (203.2 mm) deep, used mainly for hard disk drives and floppy disk drives. This is the size of the internal (screwed) part of the bay, as the front side is actually 5 + 7 ⁄ 8 inches (149.2 mm). The difference between those widths and the name of ...
Internal SuperDrive floppy drive on a Macintosh LC II. The term was first used by Apple Computer in 1988 to refer to their 1.44 MB 3.5 inch floppy drive.This replaced the older 800 KB floppy drive that had been standard in the Macintosh up to then, but remained compatible [citation needed] in that it could continue to read and write both 800 KB (double-sided) and 400 KB (single-sided) floppy ...
The TX has a 3.5" internal floppy disk drive mounted in a 5.25" bay with room for an optional second internal 3.5" or 5.25" floppy disk drive. The rear panel has the same ports as the 1000 SX, except that an RS-232C serial port replaces the light-pen port.