Search results
Results From The WOW.Com Content Network
The outdoor wood boiler is a variant on the indoor wood, oil or gas boiler. An outdoor wood boiler or outdoor wood stove is a unit about 4-6 feet wide and around 10 feet long. It is made up of four main parts- the firebox, which can be either round or square, the water jacket, the heat exchanger, and the weather proof housing.
Contemporary sustainable buildings often make use of the stack effect along with related non-electric techniques like ground coupling, earth sheltering, and evaporative cooling to enhance the passive cooling profile of a building. By carefully designing the building's structure, orientation and ventilation paths, architects can leverage the ...
An air source heat pump can be used to air condition the building during hot weather, and to warm the building using heat extracted from outdoor air in cold weather. Air-source heat pumps are generally uneconomic for outdoor temperatures much below freezing. In colder climates, geothermal heat pumps can be used to extract heat from the ground ...
The furnace used a forced and induced draft fan to draw combustion air and exhaust gases through the combustion chamber at 1/3 of the speed of sound (100 m/s+). The wood was loaded into a vertical tube which passed through the water jacket into a refractory lined combustion chamber.
During extreme cold events, you may hear a loud boom and feel like you have experienced an earthquake. However, this event was more likely a cryoseism, also known as an ice quake or a frost quake ...
Most modern hot water boiler heating systems have a circulator, which is a pump, to move hot water through the distribution system (as opposed to older gravity-fed systems). The heat can be transferred to the surrounding air using radiators , hot water coils (hydro-air), or other heat exchangers.
In a water boiler, draft is the difference between atmospheric pressure and the pressure existing in the furnace or flue gas passage. [1] Draft can also be referred to as the difference in pressure in the combustion chamber area which results in the motion of the flue gases and the air flow.
The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...