Search results
Results From The WOW.Com Content Network
Bipolar transistors, and particularly power transistors, have long base-storage times when they are driven into saturation; the base storage limits turn-off time in switching applications. A Baker clamp can prevent the transistor from heavily saturating, which reduces the amount of charge stored in the base and thus improves switching time.
This device allows operation at higher frequencies than a bipolar transistor, but is limited to low voltage applications. The Insulated-gate bipolar transistor (IGBT) was developed in the 1980s, and became widely available in the 1990s. This component has the power handling capability of the bipolar transistor and the advantages of the isolated ...
The input signal is applied across the ground and the base circuit of the transistor. The output signal appears across ground and the collector of the transistor. Since the emitter is connected to the ground, it is common to signals, input and output. The common-emitter circuit is the most widely used of junction transistor amplifiers.
A heterojunction bipolar transistor (HBT) is a type of bipolar junction transistor (BJT) that uses different semiconductor materials for the emitter and base regions, creating a heterojunction. The HBT improves on the BJT in that it can handle signals of very high frequencies, up to several hundred GHz .
A diffused junction transistor is a transistor formed by diffusing dopants into a semiconductor substrate. The diffusion process was developed later than the alloy-junction and grown junction processes for making bipolar junction transistors (BJTs). Bell Labs developed the first prototype diffused junction bipolar transistors in 1954. [1]
A typical use of these transistors is as a switch for moderate voltages and currents, including as drivers for small lamps, motors, and relays. [1] In switching circuits, these FETs can be used much like bipolar junction transistors, but have some advantages: high input impedance of the insulated gate means almost no gate current is required
A multiple-emitter transistor is a specialized bipolar transistor mostly used at the inputs of integrated circuit TTL NAND logic gates. Input signals are applied to the emitters . The voltage presented to the following stage is pulled low if any one or more of the base–emitter junctions is forward biased, allowing logical operations to be ...
A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.