Ads
related to: kitchen sink supply line size
Search results
Results From The WOW.Com Content Network
This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...
In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...
A Fixture Unit is used in plumbing design for both water supply and waste water. Different fixtures have different flow requirements. In order to determine the required size of pipe, an arbitrary unit is used for pipe sizing which takes into account the likelihood that all the fixtures will not be used at the same time. This is called "fixture ...
These compression connections on water shutoff valves under a kitchen sink show evidence of slow seepage (greenish deposits). Valves stop (or regulate) the flow of liquids or gases. They are categorized by application, such as isolation, throttling, and non-return.
Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, [36] although lead pipes were approved by national plumbing codes into the 1980s, [37] and lead was used in plumbing solder for drinking water until it was banned in 1986. [36] Drain and vent lines are made of plastic, steel, cast iron ...
A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.