Ads
related to: which detector used in ftir 5 meter sound signal antenna
Search results
Results From The WOW.Com Content Network
An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.
Fourier transform infrared spectroscopy (FTIR) [1] is a technique used to obtain an infrared spectrum of absorption or emission of a solid, liquid, or gas. An FTIR spectrometer simultaneously collects high-resolution spectral data over a wide spectral range.
An infrared detector is a detector that reacts to infrared (IR) radiation. The two main types of detectors are thermal and photonic ( photodetectors ). The thermal effects of the incident IR radiation can be followed through many temperature dependent phenomena. [ 2 ]
Detectors are used in an attempt to adequately map the correct signal power to the appropriate frequency point on the display. There are in general three types of detectors: sample, peak, and average Sample detection – sample detection simply uses the midpoint of a given interval as the display point value. While this method does represent ...
The Fellgett advantage, also known as the multiplex principle, states that when obtaining a spectrum when measurement noise is dominated by detector noise (which is independent of the power of radiation incident on the detector), a multiplex spectrometer such as a Fourier-transform spectrometer will produce a relative improvement in signal-to ...
A nondispersive infrared sensor (or NDIR sensor) is a simple spectroscopic sensor often used as a gas detector.It is non-dispersive in the fact that no dispersive element (e.g a prism or diffraction grating as is often present in other spectrometers) is used to separate out (like a monochromator) the broadband light into a narrow spectrum suitable for gas sensing.
Without the slit used in dispersive spectroscopy, FTIR allows more light to enter the spectrometer and gives a higher signal-to-noise ratio, i.e. a less-disturbed signal. [8] The IR laser used has a known wavelength and the velocity of the movable mirror can be controlled accordingly.
The detection of a single molecular complex [2] and the sensitivity to a single monolayer [3] has been shown. Recording infrared spectra as a function of position can be used for nanoscale mapping of the sample chemical composition, [4] [5] performing a local ultrafast IR spectroscopy [6] and analyzing the nanoscale intermolecular coupling, [7 ...