Search results
Results From The WOW.Com Content Network
Parallels supporting a vee block and a workpiece. A parallel is a rectangular block of metal, commonly made from tool steel, stainless steel or cast iron, which has 2, [1] 4 or 6 faces ground or lapped to a precise surface finish.
Other bottom tools are identified by function. Typical hardy tools include chisels and bending drifts. They are generally used with a matching top tool. Different hardy tools are used to form and cut metal. The swage is used to make metal a specific cross section, usually round for final use as nails, bolts, rods or rivets.
Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement. Being visible, many anchor plates are made in a style that is decorative. [5] Torque washer Used in woodworking in combination with a carriage bolt; it has a square hole in the centre into which the carriage bolt square fits. Teeth or prongs on the ...
Two sizes of metal standoffs and one plastic standoff. The background depicts a standoff in use, holding a circuit board above a metal case. A standoff is a threaded separator of defined length used to raise one part in an assembly above another. They are usually round or hex (for wrench tightening), often made of stainless steel, aluminum ...
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
A scriber is a hand tool used in metal work to mark lines on workpieces, prior to machining. The process of using a scriber is called scribing and is just part of the process of marking out . It is used instead of pencils or ink lines, because the latter are hard to see, easily erased, and imprecise due to their wide mark; scribe lines are thin ...
A hand scraper is a single-edged tool used to scrape metal or other materials from a surface. This may be required where a surface needs to be trued, corrected for fit to a mating part, retain oil (usually on a freshly ground surface), or be given a decorative finish.
A square to be tested can be presented to the master and feeler gauges used with a source of light behind the gap to get a reading of deviation. If done cleanly and correctly, this method can find errors down to 0,01 mm, which is the limit of practical accuracy since thermal expansion from contact with the fingers will distort the blade by ...