Search results
Results From The WOW.Com Content Network
Lincoln patented the first lever grease gun to work with a full stroke operation called the Model 1242. This meant that a hand-held grease gun could generate up to 10,000 lbf/in² (70 MPa) of pressure. Operators of the unit could push grease into blocked or "frozen" fittings and the unit allowed for work in confined areas.
The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [12] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun , but was cheaper to mass produce and lighter, at the expense of accuracy. [ 12 ]
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
The test grease is inserted into the container and the plunger is stroked 60 times while the test apparatus and grease are maintained at a temperature of 25 °C. Once worked, the grease is placed in a penetration test apparatus. This apparatus consists of a container, a specially-configured cone and a dial indicator. The container is filled ...
A pressure relief system is used when the volume of lubricant applied must be precise. [10] Resistant oil lubricators use the resistance of an outlet to control a continuous flow of lubricant. Further control is given by proportion adapters or oil meter adapters. Resistant oil lubricators are used when a precise volume of lubricant is less ...
Net indicated mean effective pressure (IMEP) is calculated using the indicated power; i.e., the pressure volume integral in the work per cycle equation. Sometimes the term FMEP (friction mean effective pressure) is used as an indicator of the mean effective pressure lost to friction (or friction torque) and is just the difference between IMEP ...