Search results
Results From The WOW.Com Content Network
Tire bead is the term for the edge of a tire that sits on the rim. Wheels for automobiles, bicycles, etc. are made with a small slot or groove into which the tire bead sits. When the tire is properly inflated, the air pressure within the tire keeps the bead in this groove. Reducing tire air pressure is a frequent practice among off-road vehicle ...
A tire bead is held in the groove by air pressure. A bead breaker is a tool used for separating tires from rims. The innermost diameter of the tire that interfaces with the rim of a wheel is called the tire bead. The bead is a thicker section of rubber, and is reinforced with braided steel cables, called the bead bundle. [1]
Cutaway diagram of a rim and tire from an ATV Cross section of a bicycle rim A wooden bicycle rim with tubular tire The rim is the "outer edge of a wheel, holding the tire". [ 1 ] It makes up the outer circular design of the wheel on which the inside edge of the tire is mounted on vehicles such as automobiles . [ 2 ]
Example of tire sizing on an all-terrain vehicle. Modern road tires have several measurements associated with their size as specified by tire codes like 225/70R14. The first number in the code (e.g., "225") represents the nominal tire width in millimeters. This is followed by the aspect ratio (e.g.,"70"), which is the height of the sidewall ...
Beads are bands of high tensile-strength steel wire encased in a rubber compound. Bead wire is coated with special alloys of bronze or brass. Coatings protect the steel from corrosion. Copper in the alloy and sulfur in the rubber cross-link to produce copper sulfide, which improves bonding of the bead to the rubber. Beads are inflexible and ...
The plies were turned up around the steel wire beads and the combined tread/sidewall applied. The green (uncured) tire was loaded over a curing bladder and shaped into the mold. This shaping process caused the cords in the tire to assume an S-shape from bead to bead. The angle under the tread, the crown angle, stretched down to about 36 degrees.
Clincher tires can be mounted on straight-side or crochet-type rims. Crochet-type rims are not the same as hooked-bead rims. Such tires are designated with their nominal section width and their nominal rim diameter, separated by a hyphen (-). Both are measured in millimeters. A typical example of a tire marking according to ISO 5775-1 is:
In the tire factory, the tire and wheel are mounted on a balancing machine test wheel, the assembly is rotated at 100 r/min (about 5–7 m/s (18–25 km/h; 11–16 mph) with recent high sensitivity sensors) or higher, 300 r/min (about 25–27 m/s (90–97 km/h; 56–60 mph) with typical low sensitivity sensors), and forces of unbalance are ...