Ad
related to: obd2 power and ground pin set for sale ebay cheap iphone x
Search results
Results From The WOW.Com Content Network
Typical cheap ELM327 copy without label on the controller The ELM327 is a PIC microcontroller that has been customized with ELM Electronics' proprietary code that implements the testing protocols. When ELM Electronics sold version 1.4 of its ELM327, it did not enable the copy protection feature of the PIC microcontroller.
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
For ALDL connections, pin 9 is the data stream, pins 4 and 5 are ground, and pin 16 is the battery voltage. An OBD 1.5 compatible scan tool is required to read codes generated by OBD 1.5. Additional vehicle-specific diagnostic and control circuits are also available on this connector.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
English: OBD-II type A female connector shape and pinout (The pins inside the connector are female, while the connector itself —the plastic body— is male). Español: Aspecto y posición de los contactos en un conector OBD-II hembra (los contactos son hembra, pero el cuerpo del conector es macho).
The Lightning connector was introduced on September 12, 2012, with the iPhone 5, as a replacement for the 30-pin dock connector. [3] The iPod Touch (5th generation), iPod Nano (7th generation), [4] iPad (4th generation) and iPad Mini (1st generation) followed in October and November 2012 as the first devices with Lightning.