When.com Web Search

  1. Ads

    related to: 100 x 144 inches into feet calculator tool harbor freight pressure washer

Search results

  1. Results From The WOW.Com Content Network
  2. Harbor Freight Tools - Wikipedia

    en.wikipedia.org/wiki/Harbor_Freight_Tools

    Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

  3. Board foot - Wikipedia

    en.wikipedia.org/wiki/Board_foot

    The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters.

  4. Inch of water - Wikipedia

    en.wikipedia.org/wiki/Inch_of_water

    Feet of water is an alternative way to specify pressure as height of a water column; it is conventionally equated to 2,989.067 pascals (0.4335275 psi). [ 3 ] In North America , air and other industrial gases are often measured in inches of water when at low pressure.

  5. Surface feet per minute - Wikipedia

    en.wikipedia.org/wiki/Surface_feet_per_minute

    SFM is a combination of diameter and the velocity of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.

  6. Speeds and feeds - Wikipedia

    en.wikipedia.org/wiki/Speeds_and_feeds

    Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.

  7. Inch of mercury - Wikipedia

    en.wikipedia.org/wiki/Inch_of_mercury

    Inches of mercury is also used in automotive cooling system vacuum test and fill tools. A technician will use this tool to remove air from modern automotive cooling systems, test the system's ability to hold vacuum, and subsequently refill using the vacuum as suction for the new coolant. Typical minimum vacuum values are between 22 and 27 inHg.