When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.

  3. Chassis configuration - Wikipedia

    en.wikipedia.org/wiki/Chassis_configuration

    This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...

  4. Center axle disconnect - Wikipedia

    en.wikipedia.org/wiki/Center_axle_disconnect

    Center axle disconnect on a Dana 60, in a 1999 4x4 Dodge 2500HD. A center axle disconnect system or CAD is an alternative to locking hubs. CAD systems are typically used in front drive axles on four wheel drive vehicles. A CAD system works by having an axle shaft (typically the longer shaft) split into two pieces.

  5. Mack Granite - Wikipedia

    en.wikipedia.org/wiki/Mack_Granite

    The Granite, with its extra heavy-duty chassis, high ground clearance, and high-visibility cab, was designed to be operated on construction" job sites". Dump trucks are the first standard packages. Typically 6x4 (three axles, two driven) lift axles are available. Body builders can add lift axles and extended trailing axles for higher weights.

  6. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    1st Generation Dodge Cummins trucks with non-OD transmissions are equipped with 3.07:1 "Dana 61" front axles with unique differential housings and carriers with extra clearance for the very large pinion gear. They can be easily "converted" to 3.54:1 gearing by replacing the carrier. Carrier break: 3.54:1 - 4.10:1 and 4.56:1 - 7.17:1

  7. Dana 80 - Wikipedia

    en.wikipedia.org/wiki/Dana_80

    It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.

  8. Dana 35 - Wikipedia

    en.wikipedia.org/wiki/Dana_35

    The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep

  9. Portal axle - Wikipedia

    en.wikipedia.org/wiki/Portal_axle

    Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]