Search results
Results From The WOW.Com Content Network
Due to high fuel consumption, diesel engines soon became available in this range of trucks. The B36 was discontinued in 1973, although it was no longer used in trucks after 1966. It was the last petrol truck engine built by Volvo and the only V8 engine used in any vehicle, except for the newer Yamaha-built units used in the Volvo XC90 and S80.
Volvo Cars has a long reputation as a maker of inline (or straight) engines. This list of Volvo engines gives an overview of available internal combustion engines. When Volvo started in 1927, they ordered their engines from the engine manufacturer Penta in Skövde. The first engine was the inline four-cylinder side valve 28 hp (21 kW) Type DA ...
2.5 L; 152.5 cu in (2,499 cc) straight-four, with two (pushrod-actuated) valves-per-cylinder and indirect fuel injection. 92 mm × 94 mm (3.62 in × 3.70 in), the engine size is variably referred to as either 2,500 or 2,499 cc. This engine too has been called HR 492, signifying four cylinders of 92 mm (3.62 in) bore. Timing gears, not belt.
The 1.6L 4XE1-V engine was used in the base model Geo Storm and the base model Isuzu Stylus S. 80 mm (3.15 in) 1,588 cc (96.9 cu in) 96 hp (72 kW; 97 PS) SOHC 4XE1-UW The 1.6L 4XE1-UW engine was used in the 1990-1991 Isuzu Impulse XS, in the 1990-1991 Isuzu Stylus XS, in the 1990-1991 Geo Storm GSi, and the M100 Lotus Elan.
6.2L fitted to a 1987 HMMWV. The original 6.2 L (379 cu in) diesel V8 was introduced in 1982 for the Chevrolet C/K and was produced until 1993. The 6.2L diesel emerged as a high-fuel-economy alternative to the V8 gasoline engine lineup, and achieved better mileage than Chevrolet's 4.3L V6 gasoline engine of the 1980s, at a time when the market was focused on power rather than efficiency.
Since there is no room in the V between the cylinder banks for an intake system, all the intakes are on one side of the engine, and all the exhausts are on the other side. It uses a firing order of 1-5-3-6-2-4 (which is the firing order used by most straight-six engines), rather than the common V6 firing order of 1-2-3-4-5-6 or 1-6-5-4-3-2.
This engine had many of the same basic dimensions as one of Austin's pre-war sidevalve engines - the 1125cc engine fitted in the Austin 10 which had the 88.9 mm (3.5 in) stroke common to all later B-Series engines, allowing the use of much of the same installed equipment to produce the block and crankshaft - but to an all-new OHV design.
The FWD Model B was a cab over engine truck with full-time four wheel drive powered by a 389 cubic inch straight-four Wisconsin T-head engine that produced 36 bhp (27 kW) at 1,800 rpm. The chassis was constructed with a double ladder frame, with a short inner frame carrying the engine and driveline mounted within an outer frame that mounted the ...