Ads
related to: overhead mounted floor braced stalls dimensions list of equipment images
Search results
Results From The WOW.Com Content Network
Gantry-style overhead cranes of the Hainaut quarry in Soignies, Belgium. An overhead crane, commonly called a bridge crane, is a type of crane found in industrial environments. An overhead crane consists of two parallel rails seated on longitudinal I-beams attached to opposite steel columns by means of brackets. The traveling bridge spans the gap.
Electric overhead traveling cranes or EOT cranes are a common type of overhead crane, also called bridge cranes. They consist of parallel runways, much akin to rails of a railroad, with a traveling bridge spanning the gap. [1] EOT cranes are specifically powered by electricity.
Transport equipment is used to move material from one location to another (e.g., between workplaces, between a loading dock and a storage area, etc.), while positioning equipment is used to manipulate material at a single location. [3] The major subcategories of transport equipment are conveyors, cranes, and industrial trucks.
While overhead systems typically use ducts to distribute the air, UFAD systems use the underfloor plenum formed by installation of a raised floor. The plenum generally sits 0.3 and 0.46 metres (12 and 18 in ) above the structural concrete slab, although lower heights are possible.
Overhead storage can refer to shelves, cabinets, hooks, lift tables [1] or track systems [2] mounted at height (either ceiling-hung or wall-hung), and can be a form of area-saving storage by moving storage up from the floor and utilizing the volume at height.
Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...
Drill pipe (#16) is a joint of hollow tubing used to connect the surface equipment to the bottom hole assembly (BHA) and acts as a conduit for the drilling fluid. In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe .
A spare wheel and tire is mounted behind the cab on A0 variants. On A1 variants the spare wheel and tire is located on the right-hand side of the vehicle, on the top of the engine/cooling compartments. [3] The two-seat forward control cab is a development of the original Oshkosh M977 HEMTT cab. The PLS A1 (and HEMTT A4)has a visually similar ...