Search results
Results From The WOW.Com Content Network
A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...
A type of ball and socket joint called a "torque ball" is used at one end of the torque tube to allow relative motion between the axle and transmission due to suspension travel. Later American Motors Rambler models (1962 through 1966) used a flange and cushion mount in place of the ball and socket. [5]
The torque tube surrounded the true driveshaft and exerted the force to its ball joint at the extreme rear of the transmission, which was attached to the engine. A similar method like this was used in the late 1930s by Buick and by Hudson 's bathtub car in 1948, which used helical springs that could not take fore-and-aft thrust.
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed bowden cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension. The four-bar linkage mechanism formed by the unequal arm lengths causes a change in the camber of the vehicle as it rolls, which helps to keep the contact patch square on the ground, increasing the ultimate cornering capacity of the vehicle. It also ...
The Toyota recall includes 2004–2007 model year Sequoia full-size sport utility vehicles and 2004–2006 Tundra pickups sold in the U.S. A ball joint in the front suspension may wear out causing the vehicles to be difficult or sometimes impossible to steer. Toyota reported that the defect may be the cause of 11 accidents resulting in six ...
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
English: Front right wheel of a Mercedes Vito utility van. The unusual angle is due to a ball joint failure - probably resulting from hitting a kerb too hard. The ball joint (dark protrusion at the outer tip of the lower control arm, by the tire sidewall) is no longer attached to the knuckle.