Ad
related to: how to convert intensity decibels to watts meter
Search results
Results From The WOW.Com Content Network
Radiant intensity is used to characterize the emission of radiation by an antenna: [2], = (), where E e is the irradiance of the antenna;; r is the distance from the antenna.; Unlike power density, radiant intensity does not depend on distance: because radiant intensity is defined as the power through a solid angle, the decreasing power density over distance due to the inverse-square law is ...
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
The decibel watt (dBW or dB W) is a unit for the measurement of the strength of a signal expressed in decibels relative to one watt.It is used because of its capability to express both very large and very small values of power in a short range of number; e.g., 1 milliwatt = −30 dBW, 1 watt = 0 dBW, 10 watts = 10 dBW, 100 watts = 20 dBW, and 1,000,000 W = 60 dBW.
dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...
It is the total power in watts that would have to be radiated by a half-wave dipole antenna to give the same radiation intensity (signal strength or power flux density in watts per square meter) as the actual source antenna at a distant receiver located in the direction of the antenna's strongest beam . ERP measures the combination of the power ...
The electric field strength at a specific point can be determined from the power delivered to the transmitting antenna, its geometry and radiation resistance. Consider the case of a center-fed half-wave dipole antenna in free space, where the total length L is equal to one half wavelength (λ/2).
Gain or 'absolute gain' is defined as "The ratio of the radiation intensity in a given direction to the radiation intensity that would be produced if the power accepted by the antenna were isotropically radiated". [1] Usually this ratio is expressed in decibels with respect to an isotropic radiator (dBi).
The SI unit of irradiance is the watt per square metre (symbol W⋅m −2 or W/m 2). The CGS unit erg per square centimetre per second (erg⋅cm −2 ⋅s −1 ) is often used in astronomy . Irradiance is often called intensity , but this term is avoided in radiometry where such usage leads to confusion with radiant intensity .