Search results
Results From The WOW.Com Content Network
The relationships between 8D and FMEA are outlined below: The problem statements and descriptions are sometimes linked between both documents. An 8D can utilize pre-brainstormed information from a FMEA to assist in looking for potential problems. Possible causes in a FMEA can immediately be used to jump start 8D Fishbone or Ishikawa diagrams ...
Corrective and preventive action (CAPA or simply corrective action) consists of improvements to an organization's processes taken to eliminate causes of non-conformities or other undesirable situations. It is usually a set of actions, laws or regulations required by an organization to take in manufacturing, documentation, procedures, or systems ...
A failure reporting, analysis, and corrective action system (FRACAS) is a system, sometimes carried out using software, that provides a process for reporting, classifying, analyzing failures, and planning corrective actions in response to those failures.
Slight differences are found between the various FMECA standards. By RAC CRTA–FMECA, the FMECA analysis procedure typically consists of the following logical steps: Define the system; Define ground rules and assumptions in order to help drive the design; Construct system block diagrams; Identify failure modes (piece-part level or functional)
Manufacturing engineering or production engineering is a branch of professional engineering that shares many common concepts and ideas with other fields of engineering such as mechanical, chemical, electrical, and industrial engineering. Manufacturing engineering requires the ability to plan the practices of manufacturing; to research and to ...
A3 problem solving is a structured problem-solving and continuous-improvement approach, first employed at Toyota and typically used by lean manufacturing practitioners. [1] It provides a simple and strict procedure that guides problem solving by workers. The approach typically uses a single sheet of ISO A3-size paper, which is the source of its ...
[2] The tool has seen use beyond Toyota, and is now used within Kaizen, lean manufacturing, lean construction and Six Sigma. The five whys were initially developed to understand why new product features or manufacturing techniques were needed, and was not developed for root cause analysis. In other companies, it appears in other forms.
An engineering change order (ECO), also called an engineering change notice (ECN), engineering change (EC), or engineering release notice(ERN), is an artifact used to implement changes to components or end products. The ECO is utilized to control and coordinate changes to product designs that evolve over time.