Ads
related to: rubber kick plate for wall hung sink dimensions standard height
Search results
Results From The WOW.Com Content Network
A sill plate or sole plate in construction and architecture is the bottom horizontal member of a wall or building to which vertical members are attached. The word "plate" is typically omitted in America and carpenters speak simply of the "sill". Other names are rat sill, ground plate, ground sill, groundsel, night plate, and midnight sill. [1 ...
The kick space is intended to prevent potential toe injuries and allow for closer proximity to a countertop (the toes being the furthest-extending ground-level human body parts). [2] Typical dimensions are roughly 4 inches (10 cm) high by 3 inches (7.6 cm) deep. A fully enclosed cabinet base with a kick space.
[18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps , but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.
Two general categories exist: "standard" plates, which have a center hole of approximately 25 mm (one inch), and "Olympic" plates, meant to fit on the 50 mm (two inches) sleeves of Olympic barbells. [ 2 ] [ 3 ] Standard plates are usually paired with adjustable dumbbells and Olympic plates with full-size barbells, although standard barbells and ...
The official rules do not specify the shape, height, or composition of the wall, or a specific mandatory distance from home plate (though Major League Baseball mandates a minimum distance of 250 feet (76 m) and recommends a minimum distance of 320 feet (98 m) at the foul poles and 400 feet (120 m) at center field).
In June 2013, ASME replaced Fed Spec GGG-P-463C with the American National Standard (ANS) ASME B89.3.7 – 2013 Granite Surface Plates. [7] Iso standard defines ISO8512-2 for granite surface plates, but it seems the current in use is still dating back 1990. [8]
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
Gusset plates can be made into a variety of shapes and sizes and from a range of materials. Gusset plates are usually square or rectangular, but can be triangular or made into a customized shape to fit the joint. The shape of each plate is designed so that welding or bolts can be applied to different edges of the plate. [2]