When.com Web Search

  1. Ads

    related to: moisture barrier for retaining wall ideas for driveway pictures

Search results

  1. Results From The WOW.Com Content Network
  2. Category:Moisture protection - Wikipedia

    en.wikipedia.org/wiki/Category:Moisture_protection

    Moisture protection is a barrier, made from plastics, resins and bituminous products, to prevent the travel of water; typically used on a roof, beneath a cement slab or sidewalk, along a foundation wall, or lining a bathroom floor.

  3. Damp proofing - Wikipedia

    en.wikipedia.org/wiki/Damp_proofing

    A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material applied to prevent moisture transmission. A common example is polyethylene sheeting laid under a concrete slab to prevent the concrete from gaining moisture through capillary ...

  4. Cellular confinement - Wikipedia

    en.wikipedia.org/wiki/Cellular_confinement

    Walls also can be used for lining channels and in cases of high flow, it is required that the outer cells contain concrete or cement slurry infill. CCS have been used to reinforce soft or uneven soil foundations for large area footings, for retaining wall strip footings, for load sharing of covers over pipelines and other geotechnical applications.

  5. Retaining wall - Wikipedia

    en.wikipedia.org/wiki/Retaining_wall

    A basement wall is thus one kind of retaining wall; however, the term usually refers to a cantilever retaining wall, which is a freestanding structure without lateral support at its top. [2] These are cantilevered from a footing and rise above the grade on one side to retain a higher level grade on the opposite side.

  6. Damp (structural) - Wikipedia

    en.wikipedia.org/wiki/Damp_(structural)

    More recently, systems have become available that allow plasterboard or insulation board to be used to replaster walls affected by rising damp. After the existing plaster has been hacked off the wall, a salt and moisture retardant cream is applied to the wall. The plasterboard is then applied to the wall using a salt/moisture-proof adhesive.

  7. Vapor barrier - Wikipedia

    en.wikipedia.org/wiki/Vapor_barrier

    A vapor barrier on the warm side of the envelope must be combined with a venting path on the cold side of the insulation. This is because no vapor barrier is perfect, and because water may get into the structure, typically from rain. In general, the better the vapor barrier and the drier the conditions, the less venting is required. [7]