Ads
related to: heavy duty push bars
Search results
Results From The WOW.Com Content Network
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
A bullbar on a Land Rover Discovery fitted with spotlights and a sand flag. Push bar of a police car in Abu Dhabi, used to move stranded vehicles out of the way. A bullbar or push bumper (also kangaroo bar, roo bar, winch bar or nudge bar in Australia, livestock stop [NB 1] or kangaroo device in Russia, and push bar, ram bar, brush guard, grille guard, cactus pusher, rammer, PIT bar, PIT ...
Vandal-resistant switches are usually protected by the use of robust materials, such as thick stainless steel or heavy-duty plastics. Some tamper-resistant switches are also protected against operation by using other approaches, such as hiding the switches behind a locked or screwed-down door-covered panel, or by requiring a key or passcode ...
This connector is present on newer heavy duty commercial trucks and trailers following the ISO standard and is intended to replace the combination of connectors according to standards ISO 1185 and ISO 3731. The 15-pin connector is not designed to replace the ISO 7638 connector. [18] #
A ballast tractor is a specially weighted tractor unit of a heavy hauler combination. It is designed to utilize a drawbar to pull or push heavy or exceptionally large trailer loads which are loaded in a hydraulic modular trailer. When feasible, lowboy-style semi-trailers are used to minimize the height of a load's center of mass.
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.