Search results
Results From The WOW.Com Content Network
The resulting engine was somewhat improved as to power and efficiency. The 5.9 L V8 engines followed suit in 1989, but also received the overall improved "308" cylinder heads (casting number 4448308) that featured significantly higher flowing exhaust ports and a return to the original 1971 (non-fast burn) combustion chamber.
The Chrysler 3.3 and 3.8 engines are V6 engines used by Chrysler from 1989 to 2011. This engine family was Chrysler's first 60° V6 engine designed and built in-house for front wheel drive vehicles, and their first V6 not based on a V8.
In the case of the Imperial (CG, CH) then Custom imperial (CL, CW), a new and unique straight-8 engine was created with 9 main bearings and equipped with a two-barrel downdraft carburetor. From the CW model, the cylinder head is made of aluminium. It also powered the Dodge Trucks G-80 models (1931-1934) and Fargo buses (1930-1932). [1]
The cylinder head was again changed for the 2000 model year to a more emissions-friendly design. [citation needed] This head was designated as "0331" in the casting number. Early 0331 heads are prone to cracking, causing coolant to contaminate the oil, which can lead to catastrophic engine failure.
There was a U.S. auto industry-wide shift to lower compression ratios in mid-1971, so AMC increased combustion chamber size to 58-59 cc. The first three digits of the casting number on the large chamber heads are 321, 322, or 323 depending on year. The only difference between small and large chamber Gen-3 heads is the combustion chamber size.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
The Polyspheric or Poly engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to the Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
The Slant-Six is the popular name for a Chrysler inline-6 internal combustion engine with an overhead valve reverse-flow cylinder head and cylinder bank inclined at a 30-degree angle from vertical. Introduced in 1959 for the 1960 models, it was known within Chrysler as the G-engine .