Ads
related to: spline shank rotary hammer bit set
Search results
Results From The WOW.Com Content Network
A rotary hammer, also called rotary hammer drill [1] is a power tool that can perform heavy-duty tasks such as drilling and chiseling hard materials. [2] It is similar to a hammer drill in that it also pounds the drill bit in and out while it is spinning. However, rotary hammers use a piston mechanism instead of a special clutch.
The hammer of the drill acts to accelerate only the drill bit itself, and not the large mass of the chuck, which makes hammer drilling with an SDS shank drill bit more productive. Rotational drive uses the sliding keyways that open to the end of the shank, which mate with keys in the chuck.
The rotary hammer (also known as a rotary hammer drill, roto hammer drill or masonry drill). Standard chucks and parallel-shank carbide-tipped drills have been largely superseded by SDS chucks and matching (spline shank) drills, that have been designed to better withstand and transmit the percussive forces. These bits are effective at ...
A set of torq-set bits. Torq-set is a cruciform screw drive used in torque-sensitive applications. The Torq-set head is similar in appearance to a Phillips drive in that it has a cross with 4 arms. In Torq-set however, the lines are offset from each other, so they do not align to form intersecting slots across the top of the head.
The rotary force is transmitted through wedges that fit into two or three open grooves. The bit is free to move a short distance and the hammer action moves the bit up and down within the chuck. Two sprung balls fit into closed grooves, allowing movement whilst retaining the bit. There are four standard sizes with varying shank diameters: SDS Quick
The flexibility is also used to provide accurate axial location. An HSK toolholder has both a tapered shank, and a flange with a mating surface. The shank is short (about half as long as other machine tapers), with a shallow taper, the shank is 1:9.98 and the receiver is 1:10, [15] and slightly too large to allow the flange to seat fully in the ...