Search results
Results From The WOW.Com Content Network
The power factor in a single-phase circuit (or balanced three-phase circuit) can be measured with the wattmeter-ammeter-voltmeter method, where the power in watts is divided by the product of measured voltage and current. The power factor of a balanced polyphase circuit is the same as that of any phase. The power factor of an unbalanced ...
Power factor (PF) in practical shooting competitions refers to a ranking system used to reward cartridges with more recoil. Power factor is a measure of the momentum of the bullet (scaled product of the bullet's mass and velocity), which to some degree reflects the recoil impulse from the firearm onto the shooter (see section on limitations).
A capacitive load bank or capacitor bank is similar to an inductive load bank in rating and purpose, except leading power factor loads are created, so reactive power is supplied from these loads to the system instead of vice versa. Hence for a mostly inductive load this can bring the power factor closer to unity improving the quality of supply.
For premium support please call: 800-290-4726 more ways to reach us
In an electrical grid, the short circuit ratio (or SCR) is the ratio of: the short circuit apparent power (SCMVA) in the case of a line-line-line-ground (3LG) fault at the location in the grid where some generator is connected, to: the power rating of the generator itself (GMW).
Failure mode effects and criticality analysis (FMECA) is an extension of failure mode and effects analysis (FMEA).. FMEA is a bottom-up, inductive analytical method which may be performed at either the functional or piece-part level.
In electrical engineering the load factor is defined as the average load divided by the peak load in a specified time period. [1] It is a measure of the utilization rate, or efficiency of electrical energy usage; a high load factor indicates that load is using the electric system more efficiently, whereas consumers or generators that underutilize the electric distribution will have a low load ...
m v is an irregularity factor to account for the condition of the wires. For smooth, polished wires, m v = 1. For roughened, dirty or weathered wires, 0.98 to 0.93, and for cables , 0.87 to 0.83, namely the surface irregularities result in diminishing the corona threshold voltage.