Search results
Results From The WOW.Com Content Network
ASTM A992 steel is a structural steel alloy often used in the US for steel wide-flange and I beams. Like other carbon steels, the density of ASTM A992 steel is approximately 7850 kg/m 3 (0.2836 lb/in 3). ASTM A992 steel has the following minimum mechanical properties, according to ASTM specification A992/A992M.
ASTM A500 is a standard specification published by the ASTM for cold-formed welded and seamless carbon steel structural tubing in round, square, and rectangular shapes. It is commonly specified in the US for hollow structural sections , but the more stringent CSA G40.21 is preferred in Canada.
In the United States, steel I-beams are commonly specified using the depth and weight of the beam. For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m).
Specific modulus: Modulus per unit volume (MPa/m^3) Specific strength: Strength per unit density (Nm/kg) Specific weight: Weight per unit volume (N/m^3) Surface roughness: The deviations in the direction of the normal vector of a real surface from its ideal form; Tensile strength: Maximum tensile stress of a material can withstand before ...
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
The complete test requires 500 drum revolutions at a speed of 30-33 revolutions per minute. [6] Crushed sample is then separated from fine dust on a sieve, washed, dried and weighed. [6] The test reports loss of mass to abrasion and impact, expressed as a percentage of initial sample mass. [7]
For measuring Shore A the foot indents the material while for Shore D the foot penetrates the surface of the material. Material for testing needs to be in laboratory climate storage at least one hour before testing. Measuring time is 15s. Force is 1 kg +0.1 kg for Shore A, and 5 kg +0.5 kg for Shore D. Five measurements need to be taken.
The ASTM International standard for Izod Impact testing of plastics is ASTM D256. The results are expressed in energy lost per unit of thickness (such as ft·lb/in or J/cm) at the notch. Alternatively, the results may be reported as energy lost per unit cross-sectional area at the notch (J/m 2 or ft·lb/in 2).