When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Programmable thermostat - Wikipedia

   en.wikipedia.org/wiki/Programmable_thermostat

   A battery is used to provide back-up during power failures. A rechargeable battery operates the thermostat just as in the clock thermostat, charging when the thermostat is not calling and discharging while the thermostat is calling. A non-rechargeable battery always powers the thermostat. To limit the amount of power drawn from the battery ...

3. Bimetallic strip - Wikipedia

   en.wikipedia.org/wiki/Bimetallic_strip

   Heat engines are not the most efficient ones, and with the use of bimetallic strips the efficiency of the heat engine is even lower as there is no chamber to contain the heat. Moreover, the bimetallic strips cannot produce strength in its moves, the reason why is that in order to achieve reasonables bendings (movements) both metallic strips ...

4. Wax thermostatic element - Wikipedia

   en.wikipedia.org/wiki/Wax_thermostatic_element

   While the thermostat is closed, there is no flow of coolant in the radiator loop, and coolant water is instead redirected through the engine, allowing it to warm up rapidly while also avoiding hot spots. The thermostat stays closed until the coolant temperature reaches the nominal thermostat opening temperature.

5. Thermostat - Wikipedia

   en.wikipedia.org/wiki/Thermostat

   The power is supplied by a transformer, and when the thermostat makes contact between the 24 volt power and one or two of the other wires, a relay back at the heating/cooling unit activates the corresponding heat/fan/cool function of the unit(s).

6. 48-volt electrical system - Wikipedia

   en.wikipedia.org/wiki/48-volt_electrical_system

   A 48 V system can provide more power, improve energy recuperation, [7] and allow up to an 85% decrease in cable mass. [10]12-volt systems can provide only 3.5 kilowatts, while a 48 V power could achieve 15 to 20 kW or even 50 kW. 48 volts is below the level that is considered safe in dry conditions without special protective measures. [11]

7. Heat deflection temperature - Wikipedia

   en.wikipedia.org/wiki/Heat_deflection_temperature

   The heat distortion temperature is determined by the following test procedure outlined in ASTM D648. The test specimen is loaded in three-point bending in the edgewise direction. The outer fiber stress used for testing is either 0.455 MPa or 1.82 MPa, and the temperature is increased at 2 °C/min until the specimen deflects 0.25 mm.

8. Joule heating - Wikipedia

   en.wikipedia.org/wiki/Joule_heating

   The ring circuits, or ring mains, used in UK homes are another example, where power is delivered to outlets at lower currents (per wire, by using two paths in parallel), thus reducing Joule heating in the wires. Joule heating does not occur in superconducting materials, as these materials have zero electrical resistance in the superconducting ...

9. Thermal management of high-power LEDs - Wikipedia

   en.wikipedia.org/wiki/Thermal_management_of_high...

   High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED. Most of the electricity in an LED becomes heat rather than light – about 70% heat and 30% light. [1] If this heat is not removed, the LEDs run at high temperatures, which not only lowers their efficiency, but also makes the LED less reliable, shortens its ...