Search results
Results From The WOW.Com Content Network
The 1000 series (and similar 2000 and 2400 series) is a line of automatic transmissions for on-road trucks.All are 5 or 6-speed electronically controlled units and are manufactured by Allison Transmission in Indianapolis, Indiana as well as in Baltimore, Maryland and in Erskine, Minnesota.
Allison Transmission Holdings Inc. is an American manufacturer of commercial duty automatic transmissions and hybrid propulsion systems. Allison products are specified by over 250 vehicle manufacturers and are used in many market sectors, including bus, refuse, fire, construction, distribution, military, and specialty applications.
Allison transmission families for the Bus Series include the 1000/2000 Series (B210, B220, B295), 3000 Series (B300 / B400), and 4000 Series (B500). [ 5 ] Within North America, Bus Series transmissions carry a "B" prefix to distinguish them from other vocational series transmissions manufactured by Allison.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The Allison V730 is a three-speed automatic transmission used in several makes of transit bus including the RTS, Canadian-produced Classic buses derived from the GM New Look, and Grumman Flxibles. Later production buses in the GM and Flxible line had the Allison V731 transmission, which is essentially the same unit but controlled electronically ...
Allison Engine Company pursued the engine alone, revising the design as a new wide-chord snubberless (or clapperless) titanium fan and low-pressure turbine. [1] On March 23, 1990, Allison's GMA 3007 was selected to power the Embraer EMB-145 regional jet. [2] In September 1990, it was selected for the Cessna Citation X. [1]
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
Data from The Instrumentation Design And Control of a T63-A-700 Gas Turbine Engine General characteristics Type: Turboshaft Length: 40.5 in (1,029 mm) Diameter: 22.5 in (572 mm) Dry weight: 138.5 lb (63 kg) dry Components Compressor: 6-stage axial + 1-stage centrifugal compressors Combustors: Single can combustion chamber Turbine: 2-stage axial gas generator power turbine + 2-stage axial free ...