Search results
Results From The WOW.Com Content Network
A metal's properties are an important consideration in material selection. For example, electrically dominant waves are reflected by highly conductive metals like copper, silver, and brass, while magnetically dominant waves are absorbed/suppressed by a less conductive metal such as steel or stainless steel. [2]
The crystal detector demodulates the radio frequency signal, extracting the modulation (the audio signal which represents the sound waves) from the radio frequency carrier wave. In early receivers, a type of crystal detector often used was a "cat whisker detector".
A cavity resonator is one in which waves exist in a hollow space inside the device. In electronics and radio, microwave cavities consisting of hollow metal boxes are used in microwave transmitters, receivers and test equipment to control frequency, in place of the tuned circuits which are used at lower frequencies.
Radio waves can be shielded against by a conductive metal sheet or screen, an enclosure of sheet or screen is called a Faraday cage. A metal screen shields against radio waves as well as a solid sheet as long as the holes in the screen are smaller than about 1 ⁄ 20 of wavelength of the waves. [25]
Crystal radios had no amplifying components to increase the loudness of the radio signal; the sound power produced by the earphone came solely from the radio waves of the radio station being received, intercepted by the antenna. Therefore, the sensitivity of the detector was a major factor determining the sensitivity and reception range of the ...
Traveling wave antennas are notably one of the few types of antennas that are normally not self resonant: Electrical waves induced by received radio waves travel through the antenna wire in the direction that the arriving RF signals are travelling. Only electrical waves traveling toward the feedpoint are collected; waves traveling away from the ...
These phenomena can potentially generate vibrations of the ferromagnetic, conductive parts, coils and permanent magnets of electrical, magnetic and electromechanical device, resulting in an audible sound if the frequency of vibrations lies between 20 Hz and 20 kHz, and if the sound level is high enough to be heard (e.g. large surface of ...
In radio propagation, it is represented in non-line-of-sight propagation. For example, see computation of radio wave attenuation in the atmosphere used in satellite link design. In meteorology and climatology , global and local temperatures depend in part on the absorption of radiation by atmospheric gases (such as in the greenhouse effect ...