Search results
Results From The WOW.Com Content Network
The technique is closely related to using gas adsorption to measure pore sizes, but uses the Gibbs–Thomson equation rather than the Kelvin equation.They are both particular cases of the Gibbs Equations of Josiah Willard Gibbs: the Kelvin equation is the constant temperature case, and the Gibbs–Thomson equation is the constant pressure case. [1]
The Gibbs adsorption isotherm for multicomponent systems is an equation used to relate the changes in concentration of a component in contact with a surface with changes in the surface tension, which results in a corresponding change in surface energy. For a binary system, the Gibbs adsorption equation in terms of surface excess is
A century later Gibbs [3] proposed a modification to Young's equation to account for the volumetric dependence of the contact angle. Gibbs postulated the existence of a line tension, which acts at the three-phase boundary and accounts for the excess energy at the confluence of the solid-liquid-gas phase interface, and is given as:
Diagram of thermodynamic surface from Maxwell's book Theory of Heat.The diagram is drawn roughly from the same angle as the upper left photo above, and shows the 3D axes e (energy, increasing downwards), ϕ (entropy, increasing to the lower right and out-of-plane), and v (volume, increasing to the upper right and into-plane).
The discontinuity in , and other properties, e.g. internal energy, , and entropy,, of the substance, is called a first order phase transition. [12] [13] In order to specify the unique experimentally observed pressure, (), at which it occurs another thermodynamic condition is required, for from Fig.1 it could clearly occur for any pressure in the range .
It is directly related to Gibbs phase rule, that is, the number of independent variables depends on the number of substances and phases in the system. An equation used to model this relationship is called an equation of state. In most cases this model will comprise some empirical parameters that are usually adjusted to measurement data.
By normalizing the above equation by the extent of a system, such as the total number of moles, the Gibbs–Duhem equation provides a relationship between the intensive variables of the system. For a simple system with I {\displaystyle I} different components, there will be I + 1 {\displaystyle I+1} independent parameters or "degrees of freedom".
In thermodynamics, the phase rule is a general principle governing multi-component, multi-phase systems in thermodynamic equilibrium.For a system without chemical reactions, it relates the number of freely varying intensive properties (F) to the number of components (C), the number of phases (P), and number of ways of performing work on the system (N): [1] [2] [3]: 123–125