Ads
related to: recommended anchor size
Search results
Results From The WOW.Com Content Network
The size is imprinted on the spanners in millimeter values or inch sizes with intermediate sizes in fractions (older British and current US spanners). The two systems are in general not compatible, which can result in rounding of nuts and bolts (i.e. using a 13 mm (0.51 in) spanner in place of a 1 ⁄ 2 inch (12.70 mm)).
A deep-penetrating anchor (DPA) is conceptually similar to a torpedo anchor: it features a dart-shaped, thick-walled, steel cylinder with flukes attached to the upper section of the anchor. A full-scale DPA is approximately 15 metres (49 ft) in length, 1.2 metres (4 ft) in diameter, and weighs on the order of 50–100 tonnes (49–98 long tons ...
The holding power of this anchor is at best about twice its weight until it becomes buried, when it can be as much as ten times its weight. [41] They are available in sizes from about 5 kg up to several tons.
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
An earth anchor is a device designed to support structures, most commonly used in geotechnical and construction applications. Also known as a ground anchor , percussion driven earth anchor or mechanical anchor , it may be impact driven into the ground or run in spirally, depending on its design and intended force-resistance characteristics.
Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness. Each AN size also uses its own standard thread size. AN fittings are a flare fitting, using 37° flared tubing to form a metal-to-metal seal.