Search results
Results From The WOW.Com Content Network
Battery balancing and battery redistribution refer to techniques that improve the available capacity of a battery pack with multiple cells (usually in series) and increase each cell's longevity. [1] A battery balancer or battery regulator is an electrical device in a battery pack that performs battery balancing. [2]
As the charging process continues, such a battery will reach the charger's preset cut-off more rapidly, long before it has had time to accept a complete charge. In this case the battery charger indicates the charge cycle is complete, but the battery actually holds very little energy. To the user, it appears that the battery is dying. [2]
A dry-battery was invented in Japan during the Meiji Era in 1887. The inventor was Sakizō Yai. [3] However, Yai didn't have enough money to file the patent, [4] the first patent holder of a battery in Japan was not Yai, but Takahashi Ichisaburo. Wilhelm Hellesen also invented a dry-battery in 1887 and obtained U.S. patent 439,151 in 1890. [3]
Under certain conditions, some battery chemistries are at risk of thermal runaway, leading to cell rupture or combustion. As thermal runaway is determined not only by cell chemistry but also cell size, cell design and charge, only the worst-case values are reflected here. [64]
Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]
A deep-cycle battery powering a traffic signal. A deep-cycle battery is a battery designed to be regularly deeply discharged using most of its capacity. The term is traditionally mainly used for lead–acid batteries in the same form factor as automotive batteries; and contrasted with starter or cranking automotive batteries designed to deliver only a small part of their capacity in a short ...
If you were to take a 9 volt 200 amp power supply and connect it to a six-cell "12 volt" lead acid battery, it does not matter how many amps are supplied because 9 volts is not enough to "push" power into the battery. If anything the lead-acid will backfeed the 9 volt supply until the cells are depleted to the point of being damaged from discharge.
A different form of mercury battery uses mercuric oxide and cadmium. This has a much lower terminal voltage around 0.9 volts and so has lower energy density, but it has an extended temperature range, in special designs up to 180 C. Because cadmium has low solubility in the alkaline electrolyte, these batteries have long storage life. [4]